|
|
Control for reducing the quantity of data in a wireframe model |
Decimate Wireframe
To access this dialog:
-
Activate the Solids ribbon and select Operations | Decimate
The Decimate Wireframe dialog is used to select a wireframe object, define decimation parameters, reduce amount of data in a wireframe by reducing the number of edge and wireframe faces.
Read some decimation
guidelines here...
Field Details:
Wireframe Name: displays the name ofthe wireframe object to be decimated. Note that you can use the Pick button to interactively select a wireframe object in the Design window (note that, due to the nature of the decimation command, only entire objects can be selected - you cannot perform a decimation on part of a wireframe).
Face Count: displays the number of faces in the selected wireframe.
Decimation Method: select either the faster, Quadratic Decimation (default), and the more accurate, Measured Decimation method.
|
The Quadratic method is adequate in most circumstances. |
Reduction Targets: enable the extent of the decimation process to be controlled.
-
Reduce By: % simplifies the wireframe until the requested percentage reduction has been achieved. The precise reduction may not exactly match the requested amount.
-
Maximum Error: tick the box to apply a maximum error limit for the decimation algorithm; the reduction will continue until the removal of candidate vertices would produce a greater error than that specified (in world data units). It is a tolerance which limits the distance by which a face can move when a point is deleted.
|
For wireframes where dimensions are relatively small, like an underground mine design, use a very small tolerance. |
Feature Preservation Weighting: defines what constitutes a feature and defines how important different features are.
-
Feature Edge Weight: enter a feature preserve weighting value for features defined by the corresponding (following) Feature Edge angle setting. Feature Edge Angle).
This facility could be used to preserve bench boundaries, for example.
|
|
A weighting of 0.0 will attach no importance to that feature and it will probably be lost; a value of 1.0 will try to preserve the feature; a weighting value of ; increasing the number means that those edges become increasingly less preferable for removable by the decimation algorithm. Choosing a large number e.g. 99999, should ensure that these edges are preserved (but may slow down processing, or prevent the algorithm from reaching its target reduction). |
-
Feature Edge: the angle defining what are to be classed as feature -iIt has a sharper angle than the specified Feature Edge angle.
-
Boundary Edge Weight: controls the preservation of open edges. Weighting values operate in the same way as described in the notes above.
Output: select either In-Place i.e update the selected object (performing an 'in place' update) or New Object (default) i.e. create a new object to store the decimated data set.
|
|
|
